Gauge Installation
May 30th, 2009
Today I started to install the three Stri gauges I had ordered. I was a bit hesitant about starting this as I thought it would involve some more cutting and splicing. To my surprise I found that Stri includes a plug and play harness with each gauge! All I had to do was make four splices for the initial power and ground. The harnesses include plenty of wire and they plug right into the sensor (which is included).
I also installed the oil pressure and water temperature sensors in their locations. Right now I am working on drilling the holes that will house the three gauges in the radio delete panel. Once I get that all set I am going to try to snap some pictures of my progress.