ECU Conversion Prep
May 26th, 2008
After getting done everything I needed to Saturday and Sunday, I decided to start on some prep work for the B14 ECU conversion.
If you remember, a month or two back, I purchased a complete harness from a 1996 200SX SE-R. After cutting off the B14 ECU connector and extending the wires that need extending, the harness sat in my closet.
Today, I set out to make an Excel sheet with all of the information that is needed. In the document (a link to a PDF version is below), I included the following information:
- B14 terminal number
- B15 terminal Number
- General purpose
After doing this, I labeled all of the leads from the B14 harness. After I get the Sentra inspected, I will do the same on the B15 harness before making any cuts and splices. My hope is that this will help me out in two ways:
- It will simplify the splicing process, since most of the reference work is done.
- It will allow me to find any mistakes I made quickly. Since both ends will be labeled, this should help me if I think a mistake was made.