Installation: Day 05
The last few coolant hoses and clamps I was waiting on arrived earlier this week. Today I installed the lower portion of the intake manifold as well as installing the injectors, fuel rail, and the injector wiring harnesses.
The injector harness for injector number four will not seat properly, so I have to check that out tomorrow. I may need to solder on another connector. One thing I did not realize is that the JWT fuel rail requires that the B14 air regulator unit be relocated. Right now this is not a big deal, since it seems like the air regualtor may not be needed (more research will be required).
Other then that, I need to try getting the B14 hoses for the heater core coolant inlet and outlet. The B15 ones could work, but they are a bit stretched out after almost ten years. In addition, I am going to do the same for the main vacuum hose that goes to the brake booster. I’m not sure that I can get the B15 one to work without kinking it.
I will be doing a bit more work tomorrow, so I will try and grab some pictures of the progress.